| Material Safety Data Sheet |
U.S. Department of Labor |
|
|
| May be used to comply with |
Occupational Safety and Health Administration |
|
| OSHA's Hazard Communication
Standard. |
(Non-Mandatory Form) |
|
| 29 CFR 1910.1200 Standard
must be |
Form Approved |
|
| consulted for specific requirements. |
OMB No. 1218-0072 |
|
| IDENTITY
(As used on Label and List) |
NOTE: Blank spaces
are not permitted. If any item is not applicable or no |
|
| Plast-aid® Brand Plastic - Liquid & Powder |
information
is available, the space must be marked to indicate that. |
|
| Section I |
|
|
| Manufacturer's Name |
Emergency Telephone Number |
|
| Plast-aid Corporation |
(970) 577-1000 |
|
| Address (Number Street, City, State and Zip Code) |
Telephone Number for Information |
|
| P.O. Box 2156 |
(970) 577-1000 |
|
| |
Date Prepared |
|
| Estes Park, Colorado 80517 |
April 10, 1997 |
|
| |
Signature of Preparer (optional) |
|
| |
|
|
| Section
II - Hazardous Ingredients/Identity Information |
|
| Hazardous
Components (Specific Chemical identity
Common Name(s)) OSHA
PEL ACGIH TLV Other Limits % (optional) |
|
| LIQUID: |
|
|
| METHYL METHACRYLATE - INHIBITED (CSA
80-62-6) 100ppm 100ppm (8 hr. TWA) >90% |
|
| |
|
|
| SUMMARY: Flammable. Irritant by
inhalation, in contact with skin and eye and if swallowed. |
|
| May cause sensitization
by skin contact. Hazardous polymerization
may occur |
|
| in large sealed
containers. Use adequate ventilation
to keep below exposure limit. |
|
| POWDER: |
|
|
| Contains particulates. Not Otherwise
Classified. Due to the spherical
shape of this powder, spills should |
|
| be cleaned up promptly to avoid slips
and falls. (NOTE: All other MSDS information pertains to liquid.) |
|
| Section III - Physical/Chemical
Characteristics |
|
|
| Boiling Point |
Specific Gravity (H2O = 1) |
|
| 101°C / 214°F |
0.94 |
|
| Vapor Pressure (mm Hg) |
Melting Point |
|
| 29 mm Hg @ 20°C / 68°F |
-48°C / -54°F |
|
| Vapor Density (AIR =
1) |
Evaporation Rate (Butyl Acetate = 1) |
|
| 3.5 |
> 1 |
|
| Solubility in Water |
|
|
| 1.5 % Moderately Soluble |
|
|
| Appearance and Odor |
|
| Clear colorless liquid with penetrating
acrid odor. Odor threshold is 0.2
ppm. |
|
| Section IV - Fire and Explosion
Hazard Data |
|
|
| Flash Point (Method Used) |
Flammable Limits LEL UEL |
|
| 10°C / 50°F Setaflash Closed Cup |
2.1% 12.5% |
|
| Extinguishing Media |
|
|
| Foam, Dry Chemical, CO2, Water |
|
|
| Special Fire Fighting
Procedures |
|
|
| Use water spray to cool large containers
exposed to fire. |
|
| Unusual Fire and Explosion
Hazards |
|
| Vapors are heavier than air and may travel
to ignition sources and flash back. Large sealed |
|
| containers exposed to elevated temperature
may rupture explosively due to polymerization. |
|
|
OSHA 174. Sept. 1985 |
|
|
|
|
|
|
|
|
|
|
|
|